HIGH PERFORMANCE BAR WITH 2 ZONES AND ALMA CONTROL

Example Description

• In this example the IS2250P is used to power two zones. One zone has the QFC6CS two-way ceiling speakers installed and the other the FLEX50B two-way box speakers.

• Six FLEX50Bs tapped at lower volume (25 watts) are used to provide even distribution of sound around the room. The 6.5 inch bass/midrange provides exceptional sound quality at low or high volume levels

• Sources are provided by the MYMDABCD
The MYMDABCD provides CD, SD card and USB media, DAB+/FM radio and Bluetooth.
In this example it is used to provide CD/Media as well as Bluetooth programs.

• The system is being controlled by the ALMA control software which can be used through either a direct Ethernet connection or with a tablet or other mobile device

• As well as full setup including DSP parametric EQ and routing, the ALMA control software will allow password access to be set, limiting staff control to basic features such as output volume and routing.

• The primary source in the system is the Bluetooth stream from a mobile device, however if this signal is interrupted the CD/Media player can be set as a fail-over device to take over and feed either both or specific
outputs.

• The same volume level is not always required in each zone, therefore a simple method of adjusting zone volume is often required from within the zone. VCA control via the RC1-LIN achieves this.

Additional features on the IS2250P amplifiers include,
• Full DSP - Input Matrix, Filters, Parametric Eq, Compressor / limiter, Delay, Mute, Inversion
• Four software configurable general purposes input/outputs (GPIO)
• 4 Input, 4 Output Dante® support using expansion card DM4x4
• Four software configurable general purposes input/outputs (GPIO)
• Additional 4 Analogue line inputs using expansion card ANALOGUE4

High Performance Bar with 2 zones and ALMA Control - Application Example